Sink sprayer hook up
Also observe connection between hose and diverter and make sure no leaks occur when the water supply is either on or off. Check under your sink to make sure there is a diverter connection on the water supply line so that your new sprayer hose can receive water supply.
This will hold it in place to the nut. Place the plastic washer over the clip and then the rubber washer over the plastic one. Tighten all nuts so that there will be no unnecessary leaks.
Press down so all the washers are snug against the assembly.
Step 4 — Put the Shroud Put the shroud for the sprayer in the hole and tighten the retaining nut below to keep it in place. Turn back on the water supply. How to Install an Undermount Sink in a G We welcome your comments and suggestions.
Spin it clockwise until it is securely attached. Step 5 — Connect the Hose Find the end of the sprayer hose and connect it to the diverter connection on the water supply line. In the long run, its sprayer head tends to get clogged and to sink sprayer hook up this, heat tall glass of vinegar in the microwave.
Alan Donahue started writing professionally in About the Author Alan Donahue started writing professionally in Post it on Your Projects! Turn off the water supply to the faucet and drain.
All information is provided "AS IS. If there is an extra hole available, use this extra hole next to the faucet for installing a sink sprayer attachment. The installation is a lot easier than expected and can be done without the services of a plumber.
The simple upgrade is a small touch that can make your kitchen more functional. A spray nozzle can be used for a variety of things, including single dad dating problems vegtables.
Put the shroud for the sprayer in the hole and tighten the retaining nut below to keep it in place. Slip the spray nozzle nut onto the large end of the hose. This will prevent any leaks while you install the spray nozzle. Step 1 — Check the Sink Before deciding on putting a sprayer house to your sink system, make flames match making your sink can accommodate a sprayer hose. Remove the soap dispenser if you are going to use this hole for your sprayer hose or cover over the auxiliary hole next to the faucet.
Turn the spray nozzle until it is tight, but do not overtighten it.